Skip Navigation
What 2D printers do 3D printer people prefer?
  • I have an HP inkjet printer that qualifies for their Instant Ink program. I am currently on the free plan that allows printing up to 15 pages a month for free. When the ink runs low they send me more ink (for free). If I happen to go over 15 pages/month, its only like $1 for another 10 pages, so not a big penalty.

  • Finding Something that "Just Works"
  • Wyze natively supports Google Assistant. If you are a HK user you can set up Homebridge and use the "homebridge-wyze-smart-home" plugin which supports a lot of Wyze devices and is regularly updated.

  • Just got my first iPhone since the 3G, now what?
  • One piece of advise I can give; do not try to replicate your android experience on iOS. More than likely it will leave you frustrated. Make the switch with an open mind to a new way of doing things and you will have a much better time.

  • 3D Printing beginner questions
  • I would check out the Bambu Labs P1P or Creality K1. Both are about $600 and from what I have seen print very well right out of the box. I think MicroCenter even has a $200 coupon floating around for the Creality K1 (might have to find someone to give you theirs as I think they are individualized).

  • Question about iCloud storage
  • The 200GB is shared between everyone on the family sharing plan. Did your wife set up family sharing and invite your account? If not, that needs to be done, then the 200GB will show up on your device. I would get this set up first so you see the extra 200GB, then cancel your 50GB plan. That way you know you are covered by a storage plan and not trying to rush to set something up before 30 days expire.

  • Here is my current homelab setup (now show me yours)
  • Only the one on the top is in use, and as of right now I only have one of the bottom two (gave the other away to a co-worker. If anyone on here is in the Cleveland Ohio area and could use a Cisco UCS C220 M3 for their homelab, reach out.

    Unit in use is a Cisco C220 M5SX with 2x Xeon Gold 6132 (56 total threads) and 768GB RAM, 4x 1.2TB SAS drives.

  • Here is my current homelab setup (now show me yours)
  • Current setup:

    2TB Apple Time Capsule
    48 port PoE Cicso Catalyst switch
    Unifi US8-60W switch
    Unifi USG
    QNAP 6-bay NAS with 4x 2TB and 2x 4TB WD Gold drives
    AT&T ONT and residential gateway box

  • Klipper vs Marlin
  • There is an add-on that lets the E3v2 screen work with klipper. I have it working and while the feature set is a bit limited its enough to see the print status and start a new print (among other things). You just need to run 7 wires from the screen to the GPIO pins on the pi. I used a front panel cable from an old PC case to accomplish this. Check it out!

    https://github.com/GalvanicGlaze/DWIN_T5UIC1_LCD/wiki

  • InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)AN
    anderfrank @kbin.social
    Posts 0
    Comments 31