Prusa MK4 failing X-axis test
Prusa MK4 failing X-axis test
I ran a selftest and the manual test and the X-axis keeps failing. I don't know why.
I tried:
Re-lubing
adjusting the X-axis belt
Adjusting the cables
I've had no luck with anything :/
Edit: I've watched a video and the extruder just hangs on the left side it for most the time it doesn't go left then right, right aaway
Edit 2: I found the issue that I completely overlooked cuz I was annoyed...the bearing was sticking out somehow
Prusa machines come with phenomenal support, why not consult them directly?
4 0 ReplyFigured I'd make a post while I wait the 30 minutes
3 1 Reply
@chrischryse When you (slowly) move the axis manually, does it move smoothly? All the way from one side to the other?
1 0 ReplyYup. And not sure if it matters either but x axis reads as 251
1 0 Reply@chrischryse Bummer. I'm afraid you have exhausted my troubleshooting thoughts at this point! I'd be interesting in hearing the answer...
1 0 Reply
Was it a kit? Had it been printing before you started getting this issue or was this an issue out of the box?
1 0 ReplyYep.
1 0 Reply