Skip Navigation

InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)VL
Posts
32
Comments
320
Joined
2 yr. ago

  • Do you have any recommendations for tuning filament? I've found a few videos I'm going to watch tonight, but one thing that's interesting is I just switched from a CR-10 to a K1 Max, and at the same time from Simplify3D to Creality Print and checking my old S3D profile, my flow modifier was at 1.0, but on CPrint it's at 0.95. That seems weird, but also it's manufacturer software with their printer so I'd assume they know what they're doing, but then it gives weird prints like this.

  • Yeah no you’re right and I appreciate you bringing it up. Talked about it with my wife and had an additional “is this even a nice ‘magic moment’ if it’s shilling a store?” Going to go back to blank backs and just have a little card to hand out if folks specifically ask!

  • Yeah I just moved to a K1 Max and have auto leveling for the first time, and the five batches that varied were from the same bed location so I’ll go through and make sure everything is tightened up, thank you for the idea!

  • Back to back prints so that may play into it, good point! Haven’t used it for a day so I’m kicking off a calibration and then printing a five batch to see how that looks.

    For consistent preheating are you meaning like preheat the bed and hot end and then run the calibration? I just moved to a K1 Max from a CR-10 that I paper leveled so I’m very new to auto leveling and tricks for that. Thank you for the feedback!