Skip Navigation

InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)MA
Posts
0
Comments
14
Joined
1 yr. ago

  • Finished rewiring and replacing the control board on my Robo R1+ (the first 3d printer i ever bought). It started powering off in the middle of print jobs a few years ago. So instead of replacing the stock board i bought an skr pro 1.2 control board.

    The parts have been sitting there for a while but finally spent some time on it this week. Flashed the reprap 6.5 firmware and wired up the tft-3.5 v3 control panel. Just need to finish the tuning and configuration, then it should be printing better than new.

    I have another fdm printer(creality ender 3 mqx) and a resin printer(elegoo mars 2). So this was just my 'f around and find out' project printer.