I Designed a 3D Printable Balisong Knife
I Designed a 3D Printable Balisong Knife
We've been having a good old time with this over on the Pocket Knife community, but I figure there's probably a lot of crossover with this crowd as well.
I'm sure you've seen various clever little one piece utility knife blade holders on Thingiverse and so forth, and while they're quite functional I don't think they're nearly as overwrought or silly enough, nor require quite enough components.
Rather than repeat my entire post from there over here, I'll leave you with these:
How does the blade stay secured? Years of retail has made me respect and fear bare razorblades
Maybe it’s a feature, it doubles as an improvised shuriken thrower.
The design is an interesting idea, but having suffered a few crappy box cutters I wouldn’t trust a blade with a friction fit.
It could only possibly be better if it had tits and were on fire.
Two pins go through the notches in it. It's not going anywhere.
That green one is my initial prototype and I've been pretty much continuously fidgeting with it at my desk since I printed it maybe two weeks ago. I have flipped it open and shut probably a couple of thousand times by now -- no exaggeration -- and the blade hasn't budged.
Is there like a lip or ridge on the top too that prevents the blade from flying backwards while flipping? I see it on the bottom of the blade, but can't tell if the top is also secured that way
From what it looks like you can slide it in and lock it with these two pins on top. Not sure how safe that is but considering we're talking about a makeshift balisong, safety can't be your main concern