Scissors sharpening
Scissors sharpening
I'm trying to learn how to sharpen scissors. I'm using a draw-filing technique. I'm not sure where I'm doing right or wrong. Anyone has any input? It's a little better than it was but it's definitely not as sharp as it could be. Gonna try attach some pics.
I'm having a bit of a tough time making out the bevel in your second picture - the angle looks steep but not unreasonably so. Are you flat filing the backs of the cutting faces to work the burr? Here is a guide to determine the angle you should be aiming for.
I love flat files for sharpening larger blades like my axes and hatchets (they're still finished with a stone) but tend to reach for a sharpening stone for smaller blades like scissors and secateurs. The wider face of the stone makes it easier to keep a consistent angle even without the use of a jig.
Thanks. That's helpful! I don't have a stone just yet. The angle seemed a little steeper than I expected but I couldn't tell if flattened out nearer the handle. I did some work on the back but not much, it's not concave on the backs.
It's normal for scissors to have different angles on the thumb arm than the finger arm, depending on their intended use. You shouldn't have to work the backs too much, but they should be revisited every so often during filing/honing to work the burr that is formed by the sharpening. I personally feel that a stone is more economical but you can finish hone with high grit automotive sandpaper too. If you've got an old leather belt, some scrap wood, and some glue you could make yourself a strop and only need some polishing compound. The finish work with a strop removes the burr, leaving the sharpened edge - if you don't remove the burr your tool is likely to lose the edge more quickly.
You just need to hit the angled part of the scissor blades a couple of times with the file, following the already established angle. The file is probably too coarse to make a smooth edge though. So you have anything to finish up with? A honing steel or something?
Good point! I'll try hitting it some more with the finer file or some fine sandpaper on a block. I don't have a stone just yet, or a honing steel.