What do I need to trouble shoot second hand desktop computer? And how?
What do I need to trouble shoot second hand desktop computer? And how?
[Resolved!]
I traded my cousin some really expensive RAM that I happened accross for his old desktop, that he put his graphics card into that he swapped from his newer computer. If I plug the desktop into the wall and try to turn it on nothing happens. If I open it up I can see that the where the wire from the power supply plugs into the graphics card there Is a little light on. So clearly some power is getting somewhere...
How do I go about trouble shooting this, and what tools do I need? I assume at minimum a multi meter? Not really sure what to do, it's been decades the last time I built a computer.
Board says "Asrock H110M-HDS"
Edit: Attached a Pic and noticed the light is actually on the graphics card, not motherboard. Added addtl info.
Update: So now all of the sudden the fan spins. I am at a loss as to why it spins now, as I haven't actually really done anything. I ordered a speaker for the mobo, so waiting for that.
Final update: It works! I apparently had either a bad monitor or bad display port cable. But using another monitor with DVI I was able to finally get it to fully boot!
I am not sure what got the fans to eventually work, maybe just a cable was jostled.
I really appreciate all the advice! I definitely know a lot more and feel better equipped to do things with it now.
You're viewing a single thread.
Do the fans spin up at all?
No, that's probably what's so alarming. You expect fan noise, but nothing spins.
Make sure the power button is connected to the board. Use the diagram in this PDF to locate it.
I don't see a spot for it on diagram or board. Everything is ziptied together, so it's not easy to trace back right now. The system panel header is plugged in. USB 3_3_4 is plugged. CPU fan connector is plugged.
Chassis Fan connector not plugged. USB 4_5 not plugged. Chassis intrusion and speaker header not plugged. TPM header not plugged.
Where is says panel 1 is the correct place for the connectors to the front of the case. Two of those pins are for the power button. Make sure the connector that says pwr, both + and -, are connected to the pins on the board that are labeled pwr.
That's just a sanity check to make sure the power button is correctly connected. Something less common could be the power button is broken but we won't go there just yet.