Skip Navigation

InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)ST
Posts
8
Comments
262
Joined
2 yr. ago

  • What I’m describing is really nasty, as you think the battery is let’s say at 95% and you unplug it to be used as ha handheld. It’s updating a few games and you turn around, do something else… then check back on the updates and the Deck is off because it ran out of battery in a couple of minutes. I don’t think it’s good for the battery to be drained that much

  • As I mention always whenever this topic comes up, it might be my specific setup but don’t leave it off and plugged into a dock for long periods of time: it seems to discharge the battery and not realizing it’s happened. In my experience as long as you unplug it after shutting it off, there’s no downside.

  • What happens if you leave it plugged in for half an hour or more? After that, can you unplug it? Because at least for me, the dock can drain the battery (slowly) over time when the Deck is off, all the while the battery thinks it’s full. I would try keeping it on and plugged for a while, then unplug while it’s on.

  • A thing about the official dock, maybe it’s just my setup BUT: it drains the battery. It doesn’t look like it, but if it’s off or suspended, the Deck loses charge while connected to the dock, then you grab it to use it (and the battery is like 97%!) but within 5 minutes it’s completely dead. Again, it might be just my setup, but now I unplug the Deck from the dock once it’s off.

  • The main thing IMO is to get some hands on time with it. Figure what you want, what you like, and most importantly what you would like to see improved… and go from there. See if you prefer to use it as a console, or if you want more of a gaming computer and use regularly the desktop. Maybe you’ll want a dock and how you want it will depend on your needs. You get my point :D

    Anyway for the laptop see if you like https://nobaraproject.org/download-nobara/ specifically the Nvidia one so it has the drivers pre installed. I use it “everywhere”

  • As an extra to all that’s being said so far, a food safe material doesn’t mean it has a food safe pigment in it. To be honest, if all you’re going to put into the prints are packaged items (say the tea bags) then meh, not much of a big deal IMO.

  • Lower your expectations, like… drastically. First, this is what I used for my test (quite fun even if clunky, can recommend) and as you can tell, not exactly pushing any boundaries graphic wise. Then I installed SteamVR (obviously!) and https://github.com/alvr-org/alvr to use my Quest 2. In ALVR I set the resolution to the minimum and 60 hz. Once everything was working, I went inside to SteamVR settings and… dragged the resolution to the minimum. Text was still legible in game, everything was very pixelated but usable, and the FPS kept around 60. Do note that it’s enough to give some people motion sickness, not me fortunately, but you really want to target 72 or more. In all of this the Deck was roaring with fury (docked) and as my amusement worn out, I just uninstalled SteamVR and Taskmaster because it’s really not worth it especially since on the other side of the desk I have a gaming computer.

    tl;dr works but just barely and expectations needs to be very low. Not worth it aside from curiosity.