Error during Ansible setup (SOLVED)
Error during Ansible setup (SOLVED)
Hi, I'm following the Ansible setup instructions located here: https://github.com/LemmyNet/lemmy-ansible
When I run the ansible-playbook command, I get this error. It's very long and hard to read, but I think the error is related to nginx:
Also, here's the output on my target machine when I check nginx status:
Any ideas on what I should do? After doing some Googling and asking ChatGPT, it looks like my issue might have something to do with IPv6 compatibility or something like that. Unfortunately I'm not very knowledgeable about networking stuff, so I'm not sure how to identify or fix the issue.
SOLUTION:
I solved the problem by commenting out the line listen [::]:80 in templates/nginx.conf, and also commenting out the same line on the target server in /etc/nginx/sites-available/default.
You're viewing a single thread.
try to remove
listen [::]:80;line in nginx.conf template (https://github.com/LemmyNet/lemmy-ansible/blob/main/templates/nginx.conf)It's not working, I'm still getting the same error. I don't know why it's still complaining about [::]:80 even though I commented that part out. Do I need to perform some kind of cleanup on the target server?
you should run ansible playbooks again. also you could just try to remove the line from nginx config on the server.
I got it. In addition to commenting out the
listen [::]:80line in templates/nginx.conf, I also had to comment out the corresponding line on the server at /etc/nginx/sites-available/default. Thank you!!!